bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about RV Leveling Blocks


  • Is LED Smart Level in the Hopkins RV Leveling Kit Available Separately
  • Yes! The LED Smart Level that comes with the Hopkins RV Leveling Kit # HM0820K is available separately as part # HM08201.
    view full answer...

  • Availability of a Top Cap for the Ultra-Fab Leveling Blocks
  • The Ultra-Fab leveling blocks # UF48-979051 are designed for leveling trailers and RV's and the reason they are quite rigid on top and extremely durable. I called our representative at Ultra-Fab and there isn't any type of top cap available. You can use an additional set to increase their height as needed since they are stackable.
    view full answer...

  • Grille Guard Options for 2022 Chevrolet 2500HD
  • There may be a level of obstruction when installing the Westin HDX Grille Guard with Punch Plate, # W98RV for any lower level lights in the bumper. That is the nature of the design for needed mounting location and dependent on which bumper option your vehicle is equipped with. There is also the option of the Westin HDX Modular Grille Guard with Punch Plate, # W44NF.
    view full answer...

  • Availability of Individually Controlled 4-Jack RV Leveling System
  • I believe you're looking for something like the Lippert 3.0 Ground Control 3.0 system. Unfortunately, Ultra-Fab doesn't offer a product that would allow you to individually control 4 separate jacks. The only product we offer that would do that is the # LC358590 Ground Control 3.0. Another option would be to use two of the Ultra-Fab # UF39-941705 Power Twin II, but you'd also need leveling blocks like # A10-0918 because both feet on each stabilizer jack are controlled at the same height.
    view full answer...

  • Can App Be Used With Hopkins Electronic LED Smart Level HM08201
  • There is no app compatible with the Hopkins Electronic LED Smart Level # HM08201 or any level for that matter, so you'll need to just back into the spot you want (make sure it's as level of a spot as you can find) You will need to use leveling blocks # UF48-979050 to level side to side, and the tongue jack to level front to back.
    view full answer...

  • Installation and Hardware for Stromberg Carlson Folding Handrail for RVs
  • The Stromberg Carlson Folding Handrail for RVs, # AC-530 is a complete kit, it has the needed mounting hardware. The rail and mounting hardware are not sold separately. To install, you must make sure that the rail's mounting blocks are positioned in front of a wall stud or the blocking behind the door.
    view full answer...

  • Adding Ramps To The Hopkins RV Leveling Kit with Electronic LED Smart Level
  • The Hopkins RV Leveling Kit with Electronic LED Smart Level, # HM0820K that you linked to, is an entire kit that includes 1 Smart Level device. This can be combined with the Hopkins Leveling Kit w/ Wheel Chock, # HM08200 to increase your available ramps.
    view full answer...

  • What Length Trailer Was Hopkins Electronic LED Smart Level for Trailers # HM08201 Set Up For
  • The Hopkins Electronic LED Smart Level for RVs and Trailers # HM08201 is designed to give you a rough estimate of how much further you'd need to jack the trailer up or down to get it level. Each red light will indicate 1-1/2 inches that it needs to move up or down. This can also be set to 1 inch. This was configured with the average RV length in mind so while it will work with your 45 foot long trailer you might find that the indicator lights aren't perfect in terms of the amount of inches...
    view full answer...

  • Total Travel of etrailer Electric A-Frame Trailer Jack # EJ-3520-BBX and is a Longer Leg Available
  • There isn't a longer drop leg available that is a confirmed fit for etrailer electric A-Frame jack # EJ-3520-BBX. The total amount of travel for this jack including the drop leg is 25-1/8 inches. This is the most of any of the A-frame jacks. How much more height do you need? You may consider adding some leveling blocks, # CAM44512, if you just need a few more inches.
    view full answer...

  • How Would Hopkins Smart Level be Viewed in Rear View Mirror of RV
  • Lets say you install this on the driver side wall of your RV and have it flipped out so that you can view it in your mirror. The level itself would still look correct as you look at it in the mirror. So if you were too high on the passenger side the indicator on the driver side of the green dot would illuminate.
    view full answer...

  • Available Windshield Cover to Fit a 2017 Ford E-Series Cutaway
  • We do carry a few windshield covers that will fit your RV, but the ADCO cover that you referenced, # 290-2402, will not on the 2017 Ford E-Series Cutaway. The covers we offer are not custom-fit, but are universal fit in design and are really designed to cover the windshield to protect from the winter elements. A cover like the Hopkins Heavy-Duty ArcticGuard Snow and Ice Windshield Cover, # HM17529, will not only protect during the winter months, but can be used to block out the sunshine...
    view full answer...

  • Recommended Method to Transport 2 Kayaks on 2011 Subaru Outback to Retain Rear Hatch Clearance
  • For the most flexibility in placement of two kayaks on the roof of your 2011 Subaru Outback Wagon you could use a foam block type kayak carrier such as Malone # MPG152 directly on the roof itself, bypassing the front crossbar. The front block could be positioned more forward on the roof to still give you a wide front-to-back stance for kayak stability while giving you the ability to shift the kayaks more forward for a bit more room at the back end of the car. I cannot guarantee that you'd...
    view full answer...

  • How to Adapt Timbren Rear-Axle Jounce Springs for Vehicles with 2-inches of Lift
  • It is permissible to stack two 1-inch spacers # A25723-90AH00 to give you a total of 2-inches of height adjustment for your Timbren rear axle kit. Rear axle jounce spring kits like those from Timbren are intended primarily for use with supporting cargo loads in the rear of a vehicle, more than for use when towing a trailer. A weight distribution (WD) hitch is a better option for vehicles that have rear-end sag when towing. Also, a jounce spring kit and a WD set up can tend to "fight" each...
    view full answer...

  • Replacement Return Spring Kit For Lippert Power Gear RV Leveling Jacks
  • Currently the Replacement Return Spring Kit for Power Gear External Spring RV Leveling Jacks # LC359434 are the only available springs available for the Lippert Power Gear jacks. This spring will fit both 9,000-lb (500082, 500082H, 500082HR, 500272, or 500759) and 12,000-lb (501315 or 500800) Power Gear jacks. I have included an image with the measurements for this spring.
    view full answer...

  • Lippert 6 Point Ground Control System For 2012 Forest River 5th Wheel
  • The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w/ Touchpad and Remote - 20,000 lbs, # LC358590 is the 4 point you mentioned. This is a nice system that will give you 4 point leveling. Lippert does not offer the 6 point system in an aftermarket option yet, so that is only a factory option right now. This 4 point system will allow you to automatically level your RV at a fraction of the cost of the OEM system. 4 motorized jacks raise, lower, and support your RV....
    view full answer...

  • Windows for 2004 Holiday Rambler Next Level 5th Wheel Trailer
  • I am happy to help you find what you need for your 2004 Holiday Rambler Next Level 5th wheel trailer. We have only window assemblies for the door of your RV. We have the Lippert Components 12" x 21" Inner and Outer Entry Door Window Frame with Seal - Black, # LC363370 and the Valterra Frame Assembly and Glass for RV Entrance Door - 12" x 21", # A77051. The frames are available in black, white, and brown. We unfortunately don't carry any other windows. Let me know what else you need...
    view full answer...

  • Replacement Cartridge for Flow Max RV Kitchen Faucet
  • Yes, the Flow Max RV Kitchen Faucet - Single Lever Handle - Stainless Steel, # LC719325 does have the ability to replace the cartridge. Lippert uses the type-A (Lippert part Number, 2021025928) for this faucet. If you do not already have a good water filter system in place, I suggest the AquaFresh Exterior Water Filter System w/ Wall Bracket - Single Cartridge, # AF67FR. The AquaFresh exterior water filter system reduces chlorine taste and odor, rust, sediment, ammonia, and volatile...
    view full answer...

  • Replacement 14,000 lb. Hydraulic Jack Assembly for Lippert Level Up Systems
  • We do carry some Lippert Hydraulic jacks but none by those part numbers. I tried looking them up on Lipperts site and found nothing on the 2571254 number and the 25712510 seems to have been superseded by a jack with a 14,000 lb. capacity, but not one that we carry. We do carry the Replacement Hydraulic Jack Assembly for Lippert Level Up System - 14,000 lbs # LC99ED which works with the Lippert Components Level Up RV leveling system.
    view full answer...

  • Solution for carrying canoe on the roof of a 2010 Ford Ranger single cab with 6 foot bed
  • You can always expect a reply from us here at Etrailer! I have a solution for you, however, there unfortunately is not a roof rack custom-made for the 2010 Ford Ranger standard cab. Instead, there are two routes that come to mind for you to haul your kayak on the roof. Option 1: Thule TracRac TracONE Ladder Rack w/ Cantilever - Fixed Mount - 800 lbs - Silver # TH27000XT-EX. This is a ladder rack with a cantilever that hangs over the roof, acting as a roof rack. With the three crossbars,...
    view full answer...

  • Availability of Surge Protector for 50 Amp RV Electrical Service
  • We have exactly what you're looking for. Take a look at the Camco 50 amp RV Power Defender, part # CAM55306. The Defender automatically disconnects power to protect your RV electrical system from spikes, and will reconnect when voltage levels stabilize.
    view full answer...